The Eurotech Helios/Catalyst FX Development Kit is a commercialoff-the-shelf X86-based Programmable Edge Controller. It is built aroundthree boards. The Catalyst FX Mainboard provides most of the peripheralI/O and storage media unique to this product. Attached to it are aVGA (Helios) or LVDS (Catalyst FX) daughtercard providing graphicaland console output. The system microprocessor and RAM are on theCatalyst Module. Key features are hardware support through Eurotech forreliability, rugged design, wireless capability and physical packagingoptions, ready to host an application.Board features:--------------- * Intel Atom Z5xx processor (Z520 tested @ 1.3GHz) * Intel US15W System Controller Hub (SCH) * System SDRAM - up to 2048MB * TPM (Atmel Trusted Platform Module) (optional) * ITP-XDP interface * JTAG interface * PCI Express * One I2C Bus (carrier board embedded controller) * One SMBus (SCH US15W) * VGA Graphics (Helios default) * LVDS 18-bit interface (Catalyst FX default) * Backlight with PWM control (Catalyst FX default) * Touchscreen - 4/5/8-wire, Microchip TSHARC-12S on USB * One SATA port * Compact Flash (CF) * Solid-state Disk (SSD) (optional) * Audio (Intel HD Audio) - One Stereo Line Input - One Stereo Line Output - One Stereo Microphone Input * Five USB 2.0 ports supporting low/full/high speed modes: - ports 0-4 support host mode - ports 2-4 support high current devices * Twenty-four GPIO (on SMBus) * Eight GPIO (on I2C Bus) * Eight Software-definable LEDs (using GPIO on I2C Bus and SMBus) * Boot Mode button * One serial port (EXAR USB-Serial UART) - EIA-232 or EIA-485 * Temperature sensor * Graphics - Intel SCH Poulsbo Graphics (GMA 500) - VGA & LVDS * SGX535 GPU * Intel EMGD GFX libraries * One GPS (U-Blox AG) on USB UART * One 10/100/1000-BaseT Ethernet (Intel 82574L) * Input_Devices - USB keyboards and mice, touchscreen * RTC - SCH US15W bridge RTC (HPET) * LPC bus * USB Storage * USB_Host - UHCI+EHCI * Network boot - PXE * Power Management (CPU frequency, poweroff, suspend)